This standard is issued under the fixed designation A ; the 1 This specification is under the jurisdiction of ASTM Committee A01 on Steel. Purchase your copy of ASTM A – 16 as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards available. See the chemical composition and physical properties of ASTM A Grade Steel, find alternative materials, and connect with suppliers.
| Author: | Gaktilar Shataxe |
| Country: | Cayman Islands |
| Language: | English (Spanish) |
| Genre: | Finance |
| Published (Last): | 11 August 2011 |
| Pages: | 203 |
| PDF File Size: | 15.63 Mb |
| ePub File Size: | 3.39 Mb |
| ISBN: | 367-5-23158-386-5 |
| Downloads: | 74043 |
| Price: | Free* [*Free Regsitration Required] |
| Uploader: | Gardashura |
Looking for some more information?
ASTM A506 Grade 5160
This Alloy Sheet are hot rolled or cold rolled. This abstract is a brief summary of the referenced standard.
astmm Two tension tests and two hardness tests shall be made from coupons obtained from each heat cast and heat treatment lot. Offer on Fasteners Sitemap.
Rolling is the most important industrial metal forming process. Hot Rolling is employed in breaking the ingots down into wrought products such as into blooms and billets, which are subsequently rolled to other products like plates, sheets, etc.
ASTM A506 Grade 4118
Alloy steel is furnished to chemical composition requirements and is intended primarily for general or miscellaneous use where bending and moderate forming is a requirement. This specification covers the standard for hot-rolled and cold-rolled alloy and structural alloy-steel sheet and strip.
SI units are provided for information only. Two tension tests and two hardness tests shall be made from coupons obtained from each heat cast and heat treatment lot. Heat analysis shall be performed on the material and shall conform to the required chemical compositions for carbon, manganese, phosphorus, sulfur, silicon, copper, nickel, chromium, molybdenum, and vanadium. The material shall be furnished in several conditions: ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
The material is pressed between a pair of rolls, which reduces the thickness and length is increased.
ASTM A Alloy Steel Sheet Plate Strip Supplier Manufacturer Stockist
Therefore, product design in relation to the mechanical properties of the grade used must be considered. Siddhagiri Metals and Tubes Manufacturer: The cross section of the workpiece is reduced by the process. Normally surface imperfections are not objectionable, and a good finish is not a prime requirement. Heat analysis is performed on the material and is conform to the required chemical compositions for carbon, manganese, phosphorus, sulfur, silicon, copper, nickel, chromium, molybdenum, and vanadium.
Historical Version s – view previous versions of standard. Materials in the annealed, normalized, or normalized-and-tempered condition shall be capable of meeting the longitudinal bend test requirements. Structural alloy steel is furnished to chemical composition requirements and to specific mechanical property requirements which may include tension tests, hardness tests, or other commonly accepted mechanical tests.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Siddhagiri Metals and Tubes Rating: Materials in the annealed, normalized, or normalized-and-tempered condition is capable of meeting the longitudinal bend test requirements.
Link astk Active This link will always route to the current Active version of the standard.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Rolling is the deformation of materials caused by compressive force applied through a set of rolls. The ASTM A Sheet material is furnished in several conditions like heat treatments, such as hot-rolling and cold rolling; surface conditions; and edges, as specified herein, in coils or cut lengths.