This standard is issued under the fixed designation D ; the number 1 This test method is under the jurisdiction of ASTM Committee D on Soil and Rock. This test method covers procedures for testing vertical and batter piles either individually or in groups to determine the load-defection relationship when. Grout Systems performs lateral load testing based on ASTM D, the standard test method for piles under lateral loads. Lateral Load Tests provide the most.
|Published (Last):||17 February 2015|
|PDF File Size:||12.96 Mb|
|ePub File Size:||19.73 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s – view previous versions of standard.
Test results may also provide information used to assess the distribution of lateral resistance along the pile shaft and the long-term load-deflection behavior. A foundation designer may evaluate the test results to determine if, after applying an appropriate factor of safety, the pile satm pile group has an ultimate lateral capacity and a deflection at service load satisfactory to satisfy specific foundation requirements.
ASTM D – 07 Standard Test Methods for Deep Foundations Under Lateral Load
When performed as part of a multiple-pile test program, the designer may also use the results to assess the viability of different piling types and the variability of the test site. Tests that achieve a failure load may help the designer improve the efficiency of the foundation by reducing the piling length, quantity, or size.
The test results may not represent the long-term performance of a deep foundation. Plans, specifications, provisions, or combinations thereof prepared by a qualified engineer may provide additional requirements and procedures as needed to satisfy the objectives of a particular test program. The engineer in responsible charge of the foundation design, referred to herein as the zstm, shall approve any deviations, deletions, or additions to the requirements of these test methods.
Imperative sentences indicate mandatory provisions. See Appendix X1 for comments regarding some of the factors influencing the wstm of test results. The text of these test methods references notes and footnotes which provide explanatory material.
These notes and footnotes excluding those in tables and figures shall not be considered as requirements of the test methods. These test methods also include illustrations and appendices intended only for explanatory or advisory use.
ASTM D3966/D3966M – 07(2013)e1
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
In this system, the pound [lbf] represents a unit of force [weight], while the unit for mass is slugs. How one applies the results obtained using this standard is beyond its scope. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Note 1 — The quality of the result produced by this test method is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Users of this test method are cautioned that compliance with Practice D does not in itself assure reliable results.
Reliable results adtm on many factors; Practice D provides a means of evaluating some of those factors. Specified Lateral Movement Optional. Link to Active This link will always route to the current Active version of the standard.